ESP32 GPS and CC1101 Board

5min

Product Page >

Read the Warnings before using the board!

Included Antennas

The board comes with 2.4GHz and 433MHz antennas. The shorter right angle antenna is the 433MHz antenna and should ONLY be used on the CC1101 Antenna connector on the board, labeled "CC1101_SMA". The taller antenna is the 2.4GHz antenna and should ONLY be used on the ESP32 antenna connector, labeled "ESP32_SMA".

433MHz Antenna for the CC1101
433MHz Antenna for the CC1101

2.4GHz Antenna for the ESP32
2.4GHz Antenna for the ESP32


Board Layout

Document image


Index

Setting up your Flipper Zero

Your Flipper Zero will need 3rd party firmware to use the ESP32. Check out the section Setting up your Flipper Zero for more information.

Updated 06 Jan 2024
Doc contributor
Did this page help you?
PREVIOUS
NRF24
NEXT
Warnings
Docs powered by Archbee