Mini CC1101 Board

4min

Warnings

Do not use the CC1101 while the antenna is disconnected from the board.

Do not disconnect the CC1101 Board from the Flipper Zero while in use.

Doing so can permanently damage the board.

Setting up your Flipper Zero

Newer versions of the Flipper Zero firmware should automatically detect the external CC1101 and enable the module itself. If not, you will have to enable the module manually. You can find the setting in Sub-GHz > Radio Settings > Module.

Module set to External in Sub-GHz app
Module set to External in Sub-GHz app


Once set to External, the Power LED on the Mini CC1101 board should light up.

Next Section: Using the CC1101



Updated 22 Dec 2023
Doc contributor
Did this page help you?